雖然我們對玻璃門并不陌生，但是玻璃門一旦出現問題，影響會非常大，無法合理使用。所以，玻璃門的應用并不簡單，我們要掌握一些使用要點，一起來看看吧！

Although we are not unfamiliar with glass doors, once glass doors have problems, the impact will be very large and can not be used reasonably. Therefore, the application of glass doors is not simple. We need to master some key points. Let's have a look!

1、當有人離開感應玻璃門感應器的感應區域時，感應玻璃門會延遲1-10秒后自動關閉（時間長短可以通過感應玻璃門開關的參數設置），以及感應玻璃門動作平穩無碰撞。

1. When someone leaves the sensing area of the sensing glass door sensor, the sensing glass door will automatically close after a delay of 1-10 seconds (the length of time can be set by the parameters of the sensing glass door switch), and the sensing glass door will move smoothly without collision.

2、玻璃門的開啟寬度可單獨調節，開啟寬度可設置為全部開啟或部分開啟寬度。

2. The opening width of the glass door can be adjusted separately, and the opening width can be set to the full opening or partial opening width.

3、按下急停按鈕時，電機電路被切斷，自動感應門停止。此時，可以手動推門。

3. When the emergency stop button is pressed, the motor circuit is cut off and the automatic induction door stops. At this time, the door can be pushed manually.

4、程序開關設置在“自動”或“部分開啟”位置：當有人或物體進入傳感器感應區域外時，門會自動打開。開啟暫停時間過后，門扇自動關閉。

4. The program switch is set at the "automatic" or "partially open" position: when someone or object enters outside the sensor sensing area, the door will open automatically. After the opening pause time, the door leaf will close automatically.

5、當人從門外或門內以正常速度移動到感應門時，感應玻璃門自動打開，感應玻璃門移動平穩，不發生碰撞；感應玻璃門打開后，當有人以正常速度通過感應玻璃門時，感應玻璃門保持打開狀態。

5. When a person moves to the sensing door from outside or inside the door at normal speed, the sensing glass door automatically opens, and the sensing glass door moves smoothly without collision; After the inductive glass door is opened, when someone passes through the inductive glass door at normal speed, the inductive glass door remains open.

6、當濟南玻璃門的門扇開啟到需要的部分開啟寬度時，將程序開關撥到“部分開啟”位置。此時門扇停止，系統存儲部分打開的門扇，然后門扇緩慢開啟全開位置，開啟暫停時間后門扇自動關閉。傳感器門將執行部分打開功能。

6. When the door leaf of Jinan glass door is opened to the required partial opening width, turn the program switch to the "partial opening" position. At this time, the door leaf stops, the system stores the partially opened door leaf, then the door leaf slowly opens to the fully open position, and the rear door leaf automatically closes during the opening pause time. The sensor door will perform a partial open function.

7、程序開關設置為“自動”、“單向開啟”或“部分開啟”：當有人或物體進入感應區時，門會自動開啟。開啟暫停時間過后，門扇自動關閉。

7. The program switch is set to "automatic", "one-way opening" or "partial opening": when someone or object enters the sensing area, the door will open automatically. After the opening pause time, the door leaf will close automatically.

8、為了觀察通過濟南玻璃門的正常步行路線，將日常步行路線調整到感應玻璃門面對人的方向，而不是感應玻璃門的某個角度。

8. In order to observe the normal walking route through the glass door in Jinan, adjust the daily walking route to the direction of the sensing glass door to the person, rather than a certain angle of the sensing glass door.

上述內容中為大家介紹了8個使用濟南玻璃門的關鍵點，大家在使用的時候希望大家能夠牢牢的掌握這8個關鍵點，希望能夠幫助到大家。更多內容就來關注我們網站www.t3d5.cn了解咨詢吧！

The above content introduces 8 key points for using Jinan glass doors. We hope you can firmly grasp these 8 key points when using them and help you. For more information, please follow our website www.jnkdblgd Learn about consulting. Com!